2011 Murano Button On Door Handle Not Working

This is a major problem given the snow and rain throughout the winter in the midwest not to mention the safety issue.

2011 murano button on door handle not working.

After this separate the key cylinder rod from the key cylinder assembly and while pulling the outside handle the door key cylinder assembly can be removed. How handy are you. Started after the lights were flashing as though the door was open but it was not. How to replace it yourself for only 15 20.

Now unable to open the door with any of the buttons on the key or in the car. Once you remove that cover there is a lever in there you need to pull. Then when i pressed the button in the car to open it would not. If that doesn t work then you need to push the door from inside and pull from the outside while holding the level open.

The rear door to my 2012 nissan murano won t work. First remove the front door window regulator then remove the door side grommet the door key cylinder and the outside handle escutcheon. But at the same time you pull the lever you may need someone on the outside of the door to pull. The nissan murano now uses an intelligent key system for entry.

This is normally caused by the outside door handle cable where it connects to the door latch gets jammed between operations. You can press a button on the remote or press a switch on the door handle. Replaced the rear door fuse to no avail. Do not forcibly remove the torx bolts.

Essentially there are two methods to unlock the vehicle doors and both methods require the factory programmed key fob.